Power is the rate of doing work. Electrical power refers to electrical energy transferred by an electric circuit per unit time. Its S.I unit is the watt (W). Work ∆W required to move an electrical charge ∆Q through a potential difference V is given by;
For Calculations and Formulas check the attached pdf
Materials and apparatus
This included: an assembly with resistive heating coil, electrical connector posts, stirrer, Styrofoam and an aluminum calorimeter cups, double walled calorimeter, low voltage, high current power supply, voltmeter, ammeter, electrical leads, temperature sensor and Pasco 850 Universal Interface data acquisition system.
Procedure
The Pasco 850 Universal Interface was turned on and from the start menu the Capstone software program was started. The hardware set up icon was clicked. On the hardware set up window, Add Sensor/Instrument button was then clicked to elicit another menu after which Science Workshop Analog Sensors were then selected. Temperature sensor ansd stainless steel were then chosen under Sensor/Instrument list.
The sample rate was then adjusted in the controls palette so as to take a reading every two seconds by setting the sample rate adjustment icon. The hardware setup panel was minimized by clicking on the hardware setup icon. Under the display panel, the Table and Graph icons were double clicked to display the temperature in a table and graph as a function of time. After this, the rest of the experimental devices were set up, including the calorimeter and the power supply and circuit. The mass of aluminum insert can was recorded before adding water and again after water was added. Then current was then adjusted upto about 1 amperebut not over the knife switch closed. The switch was then opened to cancel current flow before measurements started. Voltage and current values were then recorded on a data sheet.
The time for recording temperature was then set. After this, the probe and heater were then placed in water while the switch on the circuit was off. Recording button was hit and the switch flip at the same time while stirring continuously.
Calculations
For Calculations check the attached pdf
[quix id=’73’ name=’order now banner 7′]
Works Cited
Glover, J. Duncan, Mulukutla S. Sarma, and Thomas Overbye. Power System Analysis & Design, SI Version. Cengage Learning, 2012.
Hubert, C., et al. “Simulation of continuum electrical conduction and Joule heating using DEM domains.” International Journal for Numerical Methods in Engineering (2016).